Vectrix VX-2, Руководство по обслуживанию

Страница: 33 / 78

VECTRIX VX-2 SERVICE MANUAL
Version 1.0/July 2011
VECTRIX, LLC
Installation Procedure
1. Install the U-Bolt (6) into the box and start one of the nuts on the first thread of the rear stud of the U-
Bolt.
2. Slide the assembly onto the handlebar; ensure that the kill switch harness is installed into the slot of
the lower box.
3. With the lower box pivoted away from the handlebar slide the throttle assembly onto the handlebar.
4. Position the return spring (7) onto the spring post (8) of the lower box and twist the throttle until the
throttle stop is resting on the lower box throttle stop (9).
5. Ensure that the tab (10) on the bottom of the lower box is into the hole in the handlebar.
6. Using tool 01545, install the other U-Bolt nut and tighten both nuts.
7. Twist the throttle to ensure free movement and that it returns to a neutral position.
8. Using 8mm Hexagonal Socket S02445, install the kill switch cover onto the box and install the 3
screws, tighten. Alternate tightening of the 2 nuts until reaching a torque value of 2 Nm.
9. Check the Regen Throttle adjustment. Refer to Throttle Position Checking Procedure.
Note: If needed, to remove the old throttle position magnet sensor, install the new sensor magnet and
screw it in until lightly seated, then back out 1 full turn. Continue to unscrew the throttle position magnet
sensor until the throttle is properly aligned.
Regen Throttle Adjustment Procedure
Note:
Key must be in “ON” position and Kill Switch in the “OFF” position
1. Remove the right handlebar end cap. Refer to Handlebar End Cap and Hand Grip Replacement.
2. Slightly loosen the set screw (1).
https://www.motorcycle-manual.com/