5
VectorSave™ 10 launcher
Before first use
Before first use charge your parachute tube via USB connector for about 2 hours.
Testing tube by tilt
Once you have charged the launch unit it is time to test it is working correctly. Do not
press the piston down yet. hold the tube vertically and press button at the end of tube
once, you will see green light indicating the tube in powered on. Green light will stay on
for 20 seconds before tube will shut down its power. Now press the tube button again
(slightly longer) so that light turns into blinking blue. Blinking blue is indicating that tube
has registered level position and is ready to sense tilt and free fall. After you arm sensors
and have blinking blue you may tilt the tube to any direction by 90degrees and the
blinking blue will turn solid blue indicating that deployment was activated. Blue light will
remain on until you press button again and get green light for reset indication. If you arm
tube by mistake you can reset back to green by pressing the button.
Now that your sensor test is done you can load the spring. To do this you need a ph or pz
screwdriver. Holding the tube end in the palm of your hand point the end of screwdriver
to center hole of the piston and press it down until you hear click and piston is locked to
the down position. You may now repeat the tilt test while blocking the open tube end by
hand to create some resistance for piston. Without resistance the piston may pop out and
some damage may occur.
Test flight
It is important you also fly multiple test flights in normal conditions with parachute
electronics armed (blue light blinking) and confirm that blue light will not become solid
blue while flying. While doing these flights DO NOT push piston down and do not pack the
parachute inside yet. Purpose of this is to test that your parachute will not be too sensitive
for your used setup.
Should you encounter too sensitive launch contact us for support
Operating the VectorSave™ 10 launcher button - modes
1. Solid green - you get when button is pressed. Green is on for 20s before automatic shut
down.
2. Blinking blue - tube is armed and gravity is registered when button was pressed.
3. Solid blue - launch event has occurred and blue remains on until reset. Remember to
reset so you will not loose charge of your battery.
Содержание 10 Mavic
