VectorSave 10 Mavic, Руководство пользователя

Страница: 22 / 24

7
FAQ
Frequenty Asked Questions
Q: How do I know how much battery charge remains in the unit?
A: When you switch on power you will get red light blinking if the
charge is too low. We recommend also to do test launch in hand
(hold one had to block the open end to avoid piston popping out).
If battery is too low you will get red light blinking instead of
launch.
Q: Will it damage it if it is almost out of power and charged for
more than 2 hours?
A: Tube unit has built-in charge controller so it will not damage if
you leave it charging for longer time. Two hours is about what it
takes to achieve full charge.
Q: How long do you estimate the unit will likely operate on a full
charge?
A: With current latest firmware the battery last for 5 hours of
operation for basic system and 2 hours of operation for system
with built in radio.
Q: Is the position of the cap where the small opening is important
to the units operation? Same question with the tube rotation,
should it always be with label as shown in your photos or?
A: Cap positioning is meaningful only in sense that the cap should
not open by mistake, so try to figure out a good safe way to have
cap on and harness fitting nicely. We recommend the rubber band
to hold harness and I prefer the cap hole on top so that the rope
makes tight turn. The only case where the tube rotation matters is
once it is armed. Same moment the tube is armed it will register
the direction of gravity and you may no more rotate the tube.
Tube can be in any rotational position when it is armed. Arming
will define level position for using tube each time tube is armed.