OFFROAD.COM
Page 3 of 3
REV 091018
COMMENTS OR QUESTIONS PLEASE CONTACT:
VECTOR OFF ROAD
EMAIL: [email protected]
WEBSITE: http://www.vectoroffroad.com
1. Place the e-dock into the vehicle.
2. Place the left and right hand center
brackets into their place and loosely secure
them to the e-dock using a 1/4” button
head screw.
3. Replace the factory screw (keep loose
at this time) through the slot in the
e-dock center support brackets (Left and
Right side).
4. Tighten the 1/4” button head screw
and then tighten the factory screw. Do
not overtighten the hardware, especially
the factory hardware as there is not much
for it to grab on to.
5. Replace the rubber tray if you trimmed
it to fit and tighten the set screws in the
corner connectors.
JL E-DOCK MID WIDTH 2018+ INSTALLATION INSTRUCTIONS
INSTALL THE E-DOCK
6. Congratulations, installation is complete.
