OFFROAD.COM
JL E-DOCK MID WIDTH 2018+ INSTALLATION INSTRUCTIONS
Page 2 of 3
REV 091018
1. Reach inside the dash top
cubby and remove the factory
rubber liner. You may reuse
the rubber liner by cutting off
the two outside wings or
simply leave it out of the
vehicle.
PREPARE THE DASH FOR INSTALLATION
ASSEMBLE THE E-DOCK
1. Using an 1/8” hex key, insert a
1/4” set screw about half way into
each of the stubs on the machined
corner pieces. Do not put one into
the center hole.
2. Assemble the aluminum extrusion pieces to the corner pieces as shown. Position
the end caps (already installed) to the outer most edges. Make sure the extrusion
seats all the way into the corner stubs. Loosely tighten the set screws at this point.
2. Using a phillips screw driver, remove the two screws that are located under the
rubber pad removed in step 1.