INSTALLATION OF FASTENING PLATES
(FIG. 1)
(FIG. 4)
Fix the back plate to the
pillar.
(FIG. 1)
Anchor the rear part of the piston
to the plate and fasten it firmly
( FIG. 2)
1.
Fit the anchor plate onto the piston
(fig. 4)
2.
Close the gate
3.
Move the piston with the plate already fitted
towards the gate
4.
Move the fitting to limit stop, then move it
back by approximately 1 cm and mark the
position of the plate.
5.
realize the same operation in opening.
6.
If positions correspond, fix the plate on the
gate; otherwise revise
A
and
B
units
(table 1)
Installing the anchor plate on the piston to the gate
Release procedure
To unblock the operator, use
the key as shows the photo.
Turning the key of 90°, the
operator will be completely
unblocked.
Warning!
When establishing the height off the ground at which to fasten the plate
(FIG.1)
onto the
post, keep in mind the height at which the plate will be fastened
(FIG.3)
for anchoring the piston to
the gate and that the plate must be fastened 50 mm below that on the post to obtain horizontal
levelling.
(FIG. 2)
5
0
m
m
(FIG. 3)
Blocked
Unblocked
