18
TEMPERATURE WARNING
You can connect a temperature sensor to this set to give a visible and audible warning
automatically when the outside temperature becomes lower than 3°C.
See ‘INSTALLATION’ then ‘INITIAL SETTINGS’
option ‘TEMP’.
Activate / Deactivate temperature warning.
Now when the outside temperature falls below 3°C you see
TEMP WARNING
then the current
temperature displayed and hear 3 bleeps. If the temperature remains at this level you will
hear a bleep every 5 minutes and see the current temperature until it rises sufficiently and
then you will again hear 3 bleeps and see the new temperature.
A temperature sensor MUST be safely and correctly mounted.
TEMPERATURE DISPLAY
With an external temperature sensor connected and the temperature format selected in
‘INITIAL SETTINGS’ option TEMP; you can check the outside temperature by pressing the
display key as shown in ‘DISPLAY OPTIONS’.
CLOCK
This set has a clock that can either be manually adjusted by you or can be automatically updated
via the RDS signal. See ‘INITIAL SETTINGS’ option CLOCK.
You can check the time by pressing the display key as shown in ‘DISPLAY OPTIONS’.
The time transmitted via RDS can be wrong.
DEMONSTRATION MODE
In this mode, the display shows the main features of the set.
■
SWITCHING ON DEMO MODE
While keeping the Display key pressed, switch on the set. Release the Display key when you
see a change in the display. The set remains in the demonstration mode, even if you switch
the set off and then on again.
■
SWITCHING OFF DEMO MODE
Switch off the set.
Follow exactly the same procedure as ‘Switching ON demo mode’.
2
1
SPECIAL FUNCTIONS
WARNING
TEMP
TEMP
RC719/819 GB 24/02/00 15:06 Page 18