30
31
10
Caution:
DO NOT turn the soap
switch ON without solution in the
tank. DO NOT allow the solution
tank to run dry.
To post-treat carpets be sure that
the unit is stood in the upright
position. Turn the power and soap
switches on. The post-treatment
solution and water automatically mix
within the machine
Belt removal and
replacement
Remove dirty water tank and front
nozzle (see page 20) put them to
one side.
Use a Phillips screwdriver to
remove two (2) screws.
Remove the belt cover.
Remove the broken belt.
Phillips screwdriver required
1
2
3
11
N.B
The carpet treatment wand will
need priming before using to allow the
correct solution to run through. Holding
over the sink, depress the trigger for
approximately 20 seconds. The wand
will then to ready for post-treatment.
Using the wand and the trigger, apply
post-treatment solution to
carpets. Turning the spray nozzle
clockwise or anti-clockwise will
alter the spray pattern.
Releasing the trigger will stop
solution flow.
The treated areas should be left to dry.
Once dry, vacuum thoroughly.
Empty the dirty water tank as
previously directed.
Note
: Do not over wet carpets.
12
V027(Y) User Guide 5/10/06 11:47 am Page 15