• Check the ‘This pack contains’ panel on the box to make sure the
part is included with your vacuum cleaner.
• The plug may not be fully pushed into the electrical socket.
• Check the fuse in the plug if this needs replacing, always replace with a
13amp fuse.
• The motor thermostat may have tripped. If this has happened, unplug
the vacuum cleaner. Remove and empty the dirt container and check the
hose for blockages. Clean the filters and allow the vacuum cleaner to cool
for approximately 1 hour (if you have washed the filters you will need
to wait 24 hours for the filters to fully dry before putting them back into
the vacuum cleaner).
• The brushbar may be clogged, check the brush bar and clear any
hair or debris. Go to ‘Let’s talk technical’.
• The belt might be broken, go to ‘Let’s talk technical’.
• There may be a blockage in the hose. Please remove the hose from the
vacuum cleaner, check and clear any blockages. Go to ‘Let’s talk technical’,
• Empty the dirt container and clean filters. Go to the ‘Taking care of your
machine’ page*.
• The brushbar may not be turning. Go to ‘My brushbar isn’t turning?’ below.
• The brush bar height adjuster dial may not be set to the correct setting. Go to
‘Using your machine’.
• If the accessory/tool will not pick up, check and clear any blockages. Go to
‘Let’s talk technical’.
Solution
Problem
Let’s talk technical
Is there an accessory
missing?
Why does my vacuum
cleaner have no power?
Why won’t the vacuum
cleaner pick up?
My brushbar
isn’t turning?
What to do if it goes wrong
Replacing the belt
Place belt on rounded
area of brush bar
without bristles.
Line up right side of
brush bar with base,
push into place. Lift and
push left side of brush
bar until clicks into place.
Lie vacuum cleaner
on its back exposing
brush bars. Use a cross
head screwdriver.
Undo 5 screws
Line up brush bar
cover, push until it
clicks into place.
Replace 5 screws
and tighten.
Lift to remove
brush bar cover.
Lift to remove brush
bar. Remove and
dispose of old belt.
Clean any debris from spindle.
Place new belt on spindle.
Pull hose out of
hose to machine
connector.
Lift clip under the
hose inlet.
Pull latch out and
remove hose.
Remove any
blockage by
inserting wire coat
hanger into hose.
Line up latch,
push until it clicks
into place.
Removing a blockage from the hose
If the brush bar does
not rotate easily then
the belt may not have
been fitted correctly.
Make sure the belt is
not twisted.
WARNING
U86-FN_Pe_FlairEasy-Store_UG_[J2543]_Amd_01.07.14.indd 14-15
01/07/2014 14:15