Vax AWU01, Давайте начнем

Страница: 6 / 11

Taking care of your machine Taking care of your machine
Cleaning the separator
Turn separator
anti-clockwise
to ‘unlock’, pull
to remove. Using a soft brush
clean any dirt/debris
out of the separator. Tap separator over
a bin to remove
any dirt/debris. Line up tabs on
separator with dirt
container, turn
separator clockwise
to ‘lock’ and click
into place. The separator
should sit on seal
in bottom of dirt
container when
correctly itted.
Press the dirt container
release button, pull to remove.
Emptying the dirt container
Cleaning the HEPA media pre-motor ilter
Hold dirt container
over a bin. Press the dirt release clip,
allowing dirt/debris to fall out.
Turn the dirt container
lid anti-clockwise,
lift to remove.
24hr
Leave to dry for
24 hours or until
fully dry before
placing back in the
vacuum cleaner.
Turn the HEPA
media pre-motor
ilter anti-clockwise,
pull to remove. Tap HEPA media
pre-motor ilter over
a bin to remove
any dirt/debris.
Rinse under water
(max 40°C). Line up HEPA media
pre-motor ilter tabs
in dirt container lid,
turn clockwise until it
clicks into place.
IMPORTANT: The motor is equipped with a thermal cut-out. If for any reason the machine should overheat,
the thermostat will automatically turn the machine of. Switch of and unplug the vacuum cleaner. Check the
machine for blockages and clean the ilters. Wash the pre-motor ilters with warm water (40°C max) and leave
for 24 hours or until fully dry before replacing into the machine.
Filters require cleaning at least every 3-6 months (depending on the level of use).
Don’t use your vacuum cleaner without all the ilters in place.
IMPORTANT: The post motor ilter is designed to ofer long life with no maintenance. The ilter should be
checked periodically and when heavily discoloured it should be replaced. Please do not wash, scrub or brush the
ilter as this will damage it.
Post-motor ilter maintenance
Storing your vacuum cleaner
Wrap the power cable
around the quick cord
release hooks. Press handle
release button. Lower handle
downwards.
Press post-motor
ilter cover clip,
pull to remove. Remove post-
motor ilter. Check the post
motor ilter for
any discolouration.
Always use the
carry handle to lift
and carry the machine.
TIP
Don’t over ill the
dirt container to
avoid blocking the
air low through
the vacuum cleaner
and replace ilters
every 6-9 months.