www.vax.co.uk
16
maintenance
Vacuum thoroughly after carpet has completely dried. This
will help reduce any shading left by the cleaner’s brushes.
To Clean Nozzle
If lint or other debris becomes lodged in nozzle, it can be
removed for cleaning.
Unplug cleaner from electrical outlet
.
Remove both tanks as described in Fig 4/9 & Fig 4/10.
With handle in upright position, tilt cleaner back so that
handle rests on the floor.
Lift up rear edge of nozzle. Slide nozzle up and remove
from cleaner (Fig.7/3).
To replace nozzle, line up tabs (A) on nozzle with holes (B)
in cleaner. Slide tabs into holes (Fig.7/4).
Slide nozzle completely onto cleaner. Press down on
nozzle to secure it.
Replace recovery tank.
NOTE: The nozzle must be in the proper position in
order for the recovery tank to go on properly
.
Raise cleaner to upright position and replace clean water
tank (Figs. 4/12 to 4/14).
Removable Brushes
Your cleaner is equipped with removable brushes. Follow
these directions for changing brush assemblies or for easy
cleaning.
To Remove Brushes
Disconnect cleaner from electrical outlet
.
To prevent possible leaking, remove clean water tank and
recovery tank. Set tanks aside. With handle in upright
position, tilt cleaner back until handle rests on the floor
(Fig. 7/5).
Grab brush assembly and pull firmly. The brushes can be
cleaned under running water (Fig. 7/6).
To Replace Brushes
Align posts (A) on both ends of brush assembly with slots
(B) in cleaner housing. Make sure that the square post (C)
also aligns with the square hole (D). Turn brushes slightly
until post fits easily into hole.
Press brush assembly firmly to snap into place (Fig. 7/7).
Fig.7/3
Fig.7/4
A
B
Fig.7/5
Fig.7/6
