© Copyright 2015 Vauni AB - All rights reserved
Vauni Cupola
|
7
ENG
5. Lift the fireplace with the help of two people, and place it against the intended wall for
installation. Adjust it to an adequate height for mounting, and then mark at the fireplace’s
bottom edge with a pencil or the like. Vauni recommends in general a distance of 80-90 cm
from the floor to the Cupola’s bottom edge. (Figure 2)
6. Place the lower edge of the wall fixture 7.5 cm above the marked line. Make sure the wall
fixture is horizontal and then mark the three fixing holes. Figure 3.
Vauni recommends
to
investigate the function by hooking into the not yet mounted wall fixture at the back of the
Cupola.
7. Drill with appropriate drill for the wall and mount the wall fixture on the wall. Make sure the
wall fixture sits steady and gap-free against the wall. Contact a qualified professional at the
least suspicion of insufficient bearing capacity.
8. Lift the fireplace with the help of two people and hook it to the fastening rails on the top of the
wall fixture. Make sure the hook on the bottom of the wall fixture enters the hole on the back
of the Cupola. Now the fireplace is in place. Check that the attachment rail rests with its outer
ends in the upper hook of the wall rail and that the lower hook is fixed in the hole of the back
cover. Check this by gently pull the bottom of the fireplace from the wall.
This is important!
Otherwise there is a higher risk that the fireplace will fall due to external force.
9. The upper hooks on the wall fixture has a security edge that press the top of the fireplace
against the wall, just so it can be unhooked from the wall fixture. To completely secure the
Cupola to the wall fixture insert the safety pin (I) in the gap between the mounting rail on the
Cupola and the wall fixture. (Figure 4). You can also read ”Vauni recommends” under Section
3.1.6, it might be helpful.
10. Lower the burner in the provided holder into the fireplace. (Figure 5)
11. Place the regulator lid by lowering the two guide pins into the respective grooves (Figure 6A).
When correctly placed, the regulator lid should lie closely against the burner’s surface and
slide easily when the regulator rod (which grips in the holes provided in the regulator lid)
moves it to its respective stop. In the open position, the regulator lid should be in front of the
burner’s opening as seen from in front of the fireplace. (Figur 6B, 7)
Note! The regulator lid is
designed to cover the burner opening partly when the burner is open maximally. So this is
normal.
Now that the fireplace is completely assembled, read Section
4 Firing
for instructions on how to
start it the first time.
2
3
5
6
7
A
B
2
4
I
