© Copyright 2015 Vauni AB - All rights reserved
Vauni Cupola
|
17
ENG
• If the flames are so strong that the fireplace cannot be allowed to burn out, it must be
extinguished with a hand-held fire extinguisher. For more information about suitable models
of fire extinguisher, contact the rescue service (in Sweden, www.raddningsverket.se).
The regulator lid does not fit tightly against the burner disk
Possible causes:
• The regulator lid is wrongly positioned.
• A foreign object is present between the regulator lid and the burner disk.
• The regulator lid and/or the burner disk is dirty.
Measures:
• Position the regulator lid according to the instructions in Section
3.1 Assembly and
installation
.
• Remove any foreign objects.
• Lift off the regulator lid and clean it. If necessary, also clean the burner disk and the burner
opening.
The fireplace leaks after fuel is added
Possible causes:
• The burner is over-filled.
• A leak has arisen in the burner system.
• The fuel has expanded in a warm state – the burner is over-filled
Measures:
All parts of the burner system are made of high-quality stainless steel and carefully checked
against leakage before delivery. If a leak is observed or suspected, the fireplace must
immediately be extinguished and not used until the fault is fixed.
• If the burner has been over-filled, excess fuel must be removed by following the instructions
in Section 4.2.3.
• If the burner system leaks, the fireplace must not be lit under any circumstances. Contact the
place of purchase for the nearest service workshop.
