Varimixer V30, Руководство по эксплуатации

Страница: 12 / 32

12
V30 = 14 1/4”
V40 = 15 13/32”
V60 = 17 47/64”
A
djuSTmENT OF BOwL FIxINg
:
The bowl arms must be raised to normal working posi-
tion. Loosen the counter nuts
(1) (fig. 7)
and remove the
cotter pins (2) . Turn the bolts (3)
until correct fixing of the
bowl is achieved. By turning the bolts out of the extension
tube the fixing is increased. Start by turning one of the
bolts half a revolution.
The adjusting diameter shall be measured inside be-
tween the bowl arms:
Adjusting diameter:
A
djuSTmENT OF BOwL CENTErINg
:
Loosen the counter nuts (1)
(fig. 7)
and remove the cotter
pins (2) . Turn the bolts (3) until the bowl is in the centre of
the mixer. In order not to alter the fixing of the bowl, one of
the bolts must be turned out of the extension tube and the
other into
the extension tube. Use the flat beater to check
that the bowl is correctly centred and turn the planetary
head with your hand before the voltage is connected.
A
djuSTmENT OF BOwL hEIghT
:
The distance (X) is measured from the bottom side
of the bayonet hole to the surface on the bowl arms
on which the bowl rests
(fig.7a). The bowl arms
must be lifted to normal working position.
V30 = 6 3/8”
(X): V40 = 6 3/8”
V60 = 6 15/16”
Lower the bowl arms down on a wooden block so that
the weight of the bowl arms are not loading the lifting
system. Loosen the counter nut
(1), (fig.7b)
. Take out
the cutter pin (2). Take out the lifting rod (3). The lifting
bolt (4) is now loose and can be turned out or into the
lifting nut (5) , until the correct height of the bowl arms
has been reached.
fig.7a
Measuring of bowl height:
fig.7b
Adjustment of bowl height:
fig.7 Adjustment of bowl fixing and bowl centering
Adjusting diameter