Varifan IC-610, Руководство пользователя

Страница: 8 / 44

Page 8
IC-610 - Intelligent Control
1.1.3 Configurations
The IC-610 contains a microprocessor which memorizes
the operational logic programmed in the configuration
you will download. The operational logic is a software
program created for your particular configuration (ie. your
equipment and installed control modules). The
operational logic is stored inside the small configuration
module supplied with the IC-610. After the “download”,
the configuration program is stored in the main (bottom)
board. Should this board be replaced, a new download
will be required. The downloading procedure is described
later in this manual (refer to section 3.3 of this manual).
1.1.4 Applications
The IC-610 control is used for heating, cooling and
ventilation equipment in animal confinement buildings or
greenhouses. The applications where the IC-610 can be
used include the following systems:
• Multistage ventilation / heating / sprinkler systems
• Combined natural and forced ventilation systems
• Room ventilation systems
1.1.5 Control modules
The IC-610 can be integrated in a fully automated
system using its built-in program with various control
modules. Four main categories of various modules are:
ON/OFF Module :The ON/OFF module operates in an
ON/OFF switching mode using solid-
state relays (CM3-2 & CM10-2).
Actuator Module :The actuator module is used on
curtain machines and inlet actuators
which provide OPEN and CLOSE
commands.
Power Module : No special control module is required
when the IC-610 is controlling a Power
Module.
Variable Speed Module
:The variable speed module controls the
speed of regular variable speed fans.
CHAPTER 1 - INTRODUCTION
www.monitrol.com