Varian Turbo-V70, Инструкция по эксплуатации

Страница: 10 / 15

SECTION II - INSTALLATION
87-900-879-01 (A) 6
•
in the case of a string with a lenght greater than 40
characters, with:
N A K CR
Controller address
•
in the case of a wrong checksum, with:
N A K CR
Controller address
•
in the case of a parameter number not present,
with:
1 0 0 6 N O - D E F
contoll.
address
param.
address
check-
sum
CR
•
in the case of an out-limit value, with:
1 0 0 6 - R A N G E
contoll.
address
param.
address
check-
sum
CR
•
in the case of an attempt of writing a logic
parameter with a value not equal to " 000000" or " I
I I I I 1", or when the parameter is a read only one,
with:.
1 0 0 6 - L O G I C
contoll.
address
param.
address
check-
sum
CR
•
in the case of a time between two characters
greater than 1 second, with:
N A K CR
Controller address
Information obtained by the serial interface are listed in
the following table where the column "TYPE" points out
a logic variable with “D” (allowed values "000000" or
"111111") and a numeric variable with "N".
Variables with the first character of "Parameter
Number" equal to X can be either written or read.
Variables with that character equal to “1” can be only
read, equal to "1" can be only written.
PARAMETER
NUMBER
TYPE DESCRIPTION
X0002 D Low speed ON/OFF
X0003 D Pump ON/OFF
X0008 D Remote ON/OFF
10009 D Error acknowledgment:
error status clearing
00302 D K1 status
00303 N Error code: error code
displaying (see the
following table)
00306 D Normal YES/NO
00307 D Starting YES/NO
00309 N Output frequency (Hz)
00310 N Pump current * 100 (A)
00311 N Temperature (°C)
00312 N Software version
The controller sends
"QExxxx" where "xxxx” is
the CRC16 of EPROM
00313 N Power (W)
00314 N Pump life (hours)
00315 N Number of cycles
00316 N Last cycle time (minutes)
00317 N Software version. The
controller sends “Paxxxx”
where "xxxx" is the CRC16
of EEPROM
X0700 N Run up time (minutes)
(read only)
X0701 N Threshold (Hz)
X0702 D Soft-start YES/NO
X0703 D Reduced output power
(YES)
Full output power (NO)
Error Code Table
CODE DESCRIPTION
00E000 No error
OOEOO1 Output current > 15 A
0OE002 Not connected pump
0OE003 Output current > 1.5 A for 15 sec.
0OE004 Bearing temperature > 60 °C
0OE005 Heat exchanger temperature > 60 °C
0OE006 Normal not reached at run up time
0OE007 Input voltage < 16 V for 5 sec.
00EOOS Operating voltage < 10 V for 5 sec.
0OE009 Vp voltage 8V lower than no~ for 5 sec.
OOE010 Soft start ramp not ended within the
expected time