DOC: 03-925996-01
DESC:
Assy, 1177 Injector, W/Pressure Sense
PAGE:
REV
5 of 9
1
PREPARED BY: Sax Makthepharack REVISED BY:
CONTROL: INDUSTRIAL ENGINEERING
REV. DATE:
SHOWN
-
12 - 24 - 99
Steve Swihart
1.2.3
Bend the leads from a Platinum Probe (03-925374-01), 90 degrees about 1/4” from body.
1.2.4
Insert the probe end between the tube and the injector bracket.
1.2.5
Place the Platinum Probe into a Heater Block (03-925964-02).
1.2.6
Place a Injector Heater Block (03-925964-01) under the body of the Injector, and make sure the thin tube sits in the slot.
1.2.7
Set the Heater Cartridge in the slot in the block.
1.2.8
Set the -02 Heater Block in place on the lower block. It may help to put the top of the -02 Heater Block in place about 3/4” below the top of
the lower block , so you can hold the heater in place with your thumb and then slide the -02 Heater Block up until they‘re even.
1.2.9
Place a 4-40 x 7/8 Soc Cap Screw (12-312004-14), through the top hole in the both heater blocks and install a 4-40 KEPS Nut
(13-312004-00) as shown. It is easiest to install the screws from underneath.
