KC-435
10
1.4.1.1
Handlebar assembly
Put the handlebars (1) on
the anti-vibration element
(2) and screw it using bolts
(3) and washers (4).
Remove the cable cover (5)
from
the
anti-vibration
element (1), pass the cables
(6) and put the cover back
on
the
anti-vibration
element.
The
cables
and
the
accelerator bowden cable
must
pass
freely
and
smoothly.
1.4.1.2
Cutting tool cover assembly
Screw the cover (8) on the
cover holder (7) using four
M5x25 bolts (9), washers
(10, 11) and M5 nuts (12).
When using the nylon head,
install the cover brim (13)
on the cover (8).
When using the grass blade, the cover
brim (13) is not used.
1.4.1.3
Installing the blade
Remove the cover brim (13) from the cover (8).
Block the shaft by inserting the hex key (14) into the side openings
of the blade holder and the angular gearbox.
Put the friction washer (15), blade (16) and washer with cap (17)
on the shaft and screw the nut (18).
Attention! The shaft and the nut are equipped with a left-handed
thread!!
Screw the nut tight using the tubular box spanner (19).
1.4.1.4
Installing the nylon head
Install the cover brim (13) on the cover (8).
Block the shaft by inserting the hex key (14) into the side openings
of the blade holder and the angular gearbox.
Put the friction washer (15) on the shaft and screw the nylon head
(20).
Attention! The shaft and the nylon head are equipped with a left-
handed thread!!
Tighten the nylon head well with your hand.
