Vari CB-80, Перевод оригинальной инструкции

Страница: 35 / 60

CB-80 CB-80B CB-80Z CB-80ZI
1) Machine frame
2) Handlebars
3) Handlebars mount bolt
4) Wheel drive lever
5) Drive lever
6) Engine revolutions lever
7) Handle
8) Engine
9) Wheel
10) Drive belt cover
11) Gearbox drive cover
12) Sweeping cylinder gearbox
13) Sweeping cylinders
14) Mudguard
15) Turning lever
16) Support wheel
17) Spacers
18) Guide rails
19) Dozer blade
20) Reaction arm
21) Supporting wheels
22) Tube frame
23) Collector
24) Sealing strip
25) Guiding wheel
26) Lifting rod
27) Screen
28) Frame
29) Bowden cable ties
Fig. 1: Machine description
Fig. 2: Unwrapping and assembling the machine
1) Sweeping cylinder drive control lever
2) Drive control lever 3b) Revolution setting lever B&S and VARI XP-200
3a) Revolution setting lever HONDA engine 4) Sweeping cylinder turning control lever
Fig.3: Controlling elements
1 STOP :
The engine is off.

Used for turning off a started engine

Putting aside the machine

Fuel refilling

Machine transport
See the picture at the Chapter 4 .
Fig. 4: Accelerator lever positions
2 MIN :
“Turtle” position
Engine runs in neutral rpms.

Short-term work rest
3 MAX :
“Hare” position
Engine is running at maximum rpm.

Operating position

Engine cold start at B&S and
VARI XP - 200 engines
4 CHOKE :
Engine runs on choke (only HONDA engines).

Engine cold start
Fig. 5: Slower drive – turtle position Fig. 6: Faster drive – hare position
Fig. 7: Cover disassembling Fig. 8: Sticker – speed selection
Fig. 9: Setting the sweeping cylinder position
1) Collector
2) Lower part of the rod
3) Nut (piece of the rod´s upper part)
4) Upper part of the rod
5) M8 nut
6) Collector frame foot
7) Split pin
8) Spacer
9) Sweeping cylinder turning control lever
10) Plastic rest
Fig. 10: Collector assembling
Fig. 11: Collector mounting Fig. 12: Tipping the waste out of the collector
Fig. 13: Transport position of the collector Fig. 14: Dozer blade mounting
Fig. 15: Dust cover assembling Fig. 16: Mounting the dust cover
Fig. 17: Sweeping cylinder drive pulley Fig. 18: Drive pulley
Fig. 19: Handlebars bowden cables Fig. 20: Frame bowden cables
Fig. 21: Placing the sweeping cylinders gearbox Fig. 22: Replacement of the cylinder sweeping brushes
Fig. 23: Positioning bolts of bowdens and tension pulley
1) Cylinder sweeping brushes drive V-belt
2) Engine – gearbox V-belt
3) Gearbox – drive axle V- belt
4) Guiding screws for the sweeping cylinders drive belt on the gearbox driven
pulley
5) Guiding pins for the sweeping cylinders drive belt on the engine driving pulley
6) Guiding screw on the pulley
Fig. 24: V-belt route and guiding pins
1) Drive V-belt
2) Right wheel
3) Left wheel
4) Drive axle
5) Bearing bodies nut
6) Slot in the side cover of the frame
Fig. 25: Replacement of the drive V-belt
Fig. 26: Sticker – speed selection Fig. 27: Combined sticker
Fig. 28: Sticker Fig. 29: Sticker
35
re
vi
ze
1
2/
20
15