Vari Lite VL800 EVENTPAR WW, Быстрый старт

Страница: 2 / 5

2
QUICK START GUIDE
WWW.VA R I - L I T E .CO M
INTRODUCTION
1. ABOUT THIS MANUAL
The document provides installation and operation instructions for the following products:
• VL800 EVENTPAR WW
Read all instructions before installing or using this product. Retain this manual for future reference.
Additional product information and descriptions may be found on the product specifi cation sheet.
2. INCLUDED ITEMS
Each VL800 EVENTPAR luminaire includes the following items:
• VL800 EVENTPAR WW
• Quick Start Guide
3. SAFETY NOTICES
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Not for residential use. Do not use this equipment for other than intended use.
• Refer service to qualifi ed personnel. This fi xture contains no user serviceable parts.
• Prior to fi rst use, carefully inspect unit for damage from shipping.
• Installation and operation to be performed by qualifi ed personnel only.
• Use safety tether when mounting.
• Install only in locations with adequate ventilation of at least 50cm clearance from adjacent surfaces.
• Ensure sure that ventilation slots are not blocked.
• Ensure that the voltage and frequency of the power supply match the power requirements of the fi xture.
• The fi xture must be earthed/grounded to the appropriate conductor.
• Do not operate fi xture outside the ambient temperature range of 0
–
40°C.
• Do not connect the fi xture to any dimmer pack.
• New fi xtures may emit a chemical odor due to the manufacturing process. This odor will dissipate over
time.
• Note distance requirement(s) from combustible materials or illuminated objects. Do not mount near gas
or electric heaters.
• Prior to each use, carefully inspect power cables and replace any damaged cables.
• Exterior surfaces of the luminaire will be hot during operation. Take appropriate precautions.
• Continuous use of the fi xture may shorten the lifespan. Power down the fi xture when not in use.
• Clean fi xtures regularly, particularly when working in a dusty environment.
• Never touch power cables or wires while the fi xture is powered on.
• Avoid entangling power wires with other cables.
• In the event of a serious operating problem, immediately discontinue using the fi xture.
• Never turn on and off the unit time after time.
• The housing, lenses, and/or the ultraviolet fi lter must be replaced if they are damaged.
• Disconnect mains power if the fi xture is not used for a long time.
• Original packing materials can be reused for transporting the fi xture.
•
• Do not look directly at the LED light beam while the fi xture is on.
• Equipment should be mounted in locations and at heights where it will not readily be subjected to tamper-
ing by unauthorized personnel.