VARI
❋
LITE - VL1100 LED L
UMINAIRE
Q
UICK
S
TART
G
UIDE
5
24 April 2017
02.1602.0001
Connecting Power and Data
Connecting Power
The luminaire requires standard AC power distribution from 100-240 VAC, 50/60 Hz. Current required depends on the AC supply voltage
and product model. Refer to
“Current vs. Voltage” on page 6
for all models covered in this manual.
Note:
The mating Neutrik® powerCON TRUE1 connector is supplied; however, you will need to purchase or construct a cable appropriate
for your application. Available power input cables is found in
“Replacement Items/Accessories” on page 4
Figure 2: Power Connector
Depending on the application, the luminaire’s AC input cable may require a different connector. If required, install a new connector meeting
your requirements using the following wire color code reference:
WARNING:
DO NOT connect to three-phase service in countries with 240 volt power.
AVERTISSEMENT:
NE PAS se connecter au
service en trois phases dans les pays avec puissance de 240 volts.
For single-phase power at 240 volts RMS:
Wire*
Connection
Green/Yellow
AC Ground
Blue
AC Neutral
Brown
AC Line
* International (Harmonized) Standard
Connection
Pin
AC Neutral
X
AC Line
Y
Ground (Earth)
G
AC Power Input
Input Panel Connections
Neutrik® powerCON TRUE1
AC Input Connector
Data In
Data Thru
3-Pole Neutrik
Locking Connector
for AC Input
EMPTY
PLUG
3-Pole Neutrik® powerCON TRUE1
for AC Input Power
X
Y
G
