VARI
❋
LITE - VL1100 LED L
UMINAIRE
Q
UICK
S
TART
G
UIDE
11
24 April 2017
02.1602.0001
For example, the
Address
function has one sub-level: DMX. This 2nd level menu allow access to a 3rd level, which is a value. The Address
function is a three-level menu.
Menu Default State
The menu displays default state during normal operation is to display the address. After 10 seconds of inactivity at the display, it will change
to this default state.
After 5 minutes of inactivity, the menu display will switch to its off state.
Program Starting Address
The DMX starting address is entered using the Menu Display. This address will be retained even if the power is removed.
Refer to your console operating instructions for specific information regarding its addressing requirements.
To program a DMX starting address:
Step
1. Press [Menu].
Step
2. Press [
] arrows until Address appears. Press [Enter].
Step
3. DMX will appear. Press [Enter].
Step
4. Press [
] arrows to enter starting address.
Step
5. Press [Enter] to set.
Program Starting Address Without Calibrating
It is possible to bypass the calibration sequence and go directly to the Menu Display programming in order to pre-program an address setting.
To program starting address without calibrating luminaire:
Step
1. While powering up luminaire, press and hold [Menu].
Step
2. Program address as described in
“Program Starting Address” on page 11
Step
3. Release when display reads ":"
The luminaire will require a reset to restore control.
1st Level
2nd Level
3rd Level
Address
DMX
XXX
