VARDE OVNE Samso, Инструкция по установке и эксплуатации

Страница: 6 / 19

6
The chimney:
Always use a chimney with a diameter of at least 15 cm. This corresponds to a clear of 175 cm
2
.
Make sure the chimney is of a sufficient height, that it draws well and that smoke does not both-
er your neighbours.
We recommend that you fit your chimney with a damper, allowing for draft control. This may
prove particularly important on windy days.
Note: the damper must never shut off draught completely – always allow at least 20 cm² free
passage through the chimney.
With nominal usage the stove has tested a flue gas flow of 5,5 g/second and with a flue gas
temperature of 340°C in a room of 20 °C.
Varde stoves are always fitted with a smoke plate which redirects smoke to make its way to the
chimney as effectively as possible. This ensures that the heat from the smoke is emitted inside
your home rather than outside it. The smoke plate is moveable and placed on top of the Vermic-
ulite fire brick side plate. You should make sure that it is pushed all the way back against the
back wall of the combustion chamber.
Draught conditions
Consult your local stove dealer about how best to adjust the draught in your chimney.
Hight of chimney
If in doubt, contact your local stove dealer. He will be able to inform you of the correct hight.
Connection of Flue pipe:
The Stove is mounted with Flue adaptor on the top.
Information about the new cast iron adapter, Part no.: 134
Your stove is equipped with the new cast iron adapter from Varde Ovne.
The adapter is suitable for smoke pipes with inner diameter on 150 mm.
If you need it, it’s now possible for you to make a condensate drain-hole in the adapter.
♦ Carefully punch a chisel or the like through the adapter in the outer groove, at the arrow
mark. This way you can establish a condensate drain hole in the adapter.
Arrow mark for the hole.
Now the condensate – hole is
ready. Carefully punch a hole with a
chisel or the like.