Vapor Clean Blue Evolution, Руководство пользователя

Страница: 6 / 18

Ø
The steam symbol will illuminate
on the console signaling the Blue
Evolution is in
Steam Mode .
Ø
This symbol will start flashing,
signaling the boiler is heating.
Ø
Squeeze the RED trigger on the hose
handle to release steam.
Ø
Steam Pressure can be increased (+)
or decreased (-) on the side of hose
handle.
Steam Pressure Setting:
Ø
3 – Heavy soil or grease
Ø
2 – Recommend for most cleaning
Ø
1 – Light soil / Delicate surfaces
Steam Pressure
Adjustment
The wet/dry vacuum on the Blue
Evolution can be used independently or
with the
Steam and Extraction . Utilize
the vacuum to reduce surface moisture
while cleaning.
Ø
Fill the collection tank with water
before using the vacuum (see page 8).
Ø
Do not exceed the GREEN max fill
line on the tank.
Ø
The vacuum has three suction
settings indicated by the color of the
LED light on the console.
Ø
Suction can be increased (+) or
decreased (-) on the side of hose
handle.
Green = Low Suction
Orange = Medium Suction
Red = High Suction
The Blue Evolution vacuum tank can
hold
½ gallon of water. If you exceed
this amount the suction will stop and the
LED will blink.
Ø
Activate the Vacuum by
pushing the symbol on
the hose handle
This symbol will flash during
operation indicating the Blue Evolution
is reheating.
Steam Trigger
Steam Vacuum
6
9
Look foward to it.
Start-up steam with hot water module Start-up suction
The soaking effect and, thus, cleaning performance can be
increased for heavy soiling by switching the hot water mo-
dule to steam.
INFO:
Do not use on sensitive surfaces or materials.
Switching on “hot water module”
Press button C on the control panel to activate the hot wa-
ter module. The symbol
N
on the display begins to flash.
Pressing button
T4
on the handle for the hot water module
switches the function on and symbol
N
on the display stays
illuminated.
Always use button
T4
on the handle to switch the hot water
module on and off.
T3
T4
The "hot water module" flow-through can be adjustet, by
pressing the button C in 10% increments. This is indicated
between 010 an 100 in the display.
Display shows 010 = 10% minimum amount of hot water
Display shows 100 = 100% maximum amount of hot water
Suction
Press button
B
on the display to activate suction.
LED
D
for suction turns red. (Suction mode 3 = max.)
Press button
T3
on the handle to switch on suction.
Briefly press button
T5
+ or
T5
on the side to vary suction
power.
MIN = LED
D
turns green
MED = LED
D
turns orange
MAX = LED
D
turns red
Press button
T3
briefly to turn suction off again.
INFO:
As there is liquid in the hose and in the extension pipes du-
ring suction operation, the sucker should not disconnected
immediately after cleaning finishes.
A short delay (approx. 30 seconds) is required.
T5
B
D
C N
1
3
2
Steam Pressure
setting
Blue Evolution is Ready when:
Ø
Temperature ≥ 330 ℉
Ø
It will take 10 minutes for the
steamer to heat and reach working
temperature
WARNING: STEAM GENERATED BY THE BLUE EVOLUTION IS EXTREMLY HOT AND MAY
CAUSE INJURY IF THE STEAM COMES IN DIRECT CONTACT WITH THE SKIN OR EYES. USE
AS ONLY AS DIRECTED BY THE THIS MANUAL AND ONLY AIM THE STEAM HANDLE AT THE
CLEANING AREA.