Vapor Clean Blue Evolution, Руководство пользователя

Страница: 8 / 18

Assembly
Collection Tank
Assembly
8
The collection tank can hold ½ gallon of water. If you exceed this amount, the
fill level sensor will stop suction and the warning display will flash.
7
Look foward to it.
Assembly / preparation
Filling the filter bowl
Your appliance is fitted with a hygienic water filter. You must
fill the filter bowl with water before starting, in order to bind
the extracted dirt in the water and to clean the suctioned air
in the water bath as well.
• Loosen the clips on the right and left of the filter bowl and
remove from its slot.
• Open the cover on the filter bowl by pushing off the rele-
vant clips.
• Fill with tap
water
up to the
green line
(approx.
2.0 litres).
• Re-insert the filter bowl, ensuring the switch cam on the
cover is in the correct position.
WARNING:
The appliance can suck in up to approx. 1.5 litres of liquid.
If you exceed this amount, the fill level sensor will stop suc-
tion automatically and LED D (page 2) on the display will
flash.
INFO:
If you only wish to suction liquid, such as accidental water
spills, it is not necessary to fill the appliance's filter bowl with
water.
When sucking liquids, the MAX. capacity in the container is
approx. 4 litres.
Inserting the steam suction hose
• Insert the connector of the steam suction hose into the
socket until you hear the click of the safety hook.
• To remove the hose from the appliance, press release but-
ton A and pull on the connector.
A
Ø
Remove by pulling latches out, located on
the sides of the tank, and slide off.
Ø
Remove the lid and fill the tank with water to the
GREEN fill line.
Ø
Secure the lid to the tank before re-installing.
Ø
To install the tank, pull out the latches and slide
tank onto the back of the Blue Evolution.
Ø
Use the latches to lock tank in place. It should
slide smoothly and fit tightly.
Accessory Box
The accessory box fits securely on the
handle using two fixed knobs. Tighten
by turning knobs clockwise.
Ø
Attach screw knobs
located on each side
Ø
Sits in groove on
handle
Push Handle
Ø
Attach by placing over fixed screw studs
located on each side and secure with the 2
small knobs. Use the washers with small
knobs.
Ø
Secure handle
with the larger
knobs, by turning
clockwise until
tight.