Vanguard 342, Руководство по установке

Страница: 96 / 115

4-8 Powering Up and Loading Software
Accessing the Control Terminal Port
Alternative Methods for Accessing the CTP
Introduction
This section describes alternative methods for accessing the CTP over a Frame Relay
Bypass connection when:
• the terminal of the local Vanguard device does not have IP connectivity or
• cannot connect to the target device over the LAN (serial port only)
• the WAN is not using X.25 or Annex G
Using Remote
Telnet VanguardMS Vanguard devices have a built-in Telnet feature that allows to you
access the CTP of other Vanguard devices. To use this feature, both the local and
target devices must be configured using an IP network connection. Use these steps to
access the CTP of another Vanguard device from your local node:
1) Access the local Vanguard’s CTP.
2)
Select the Diagnostics Menu, and then select Telnet.
3) Type any IP address that is configured in the target Vanguard.
Using SoTCP
If the target Vanguard device has been previously configured for a particular network
connection using SoTCP and AT PAD, you can access the CTP using Frame Relay
Bypass. Use these steps to establish an SoTCP connection to the target Vanguard’s
CTP using Frame Relay Bypass:
1)
From the (*) prompt, type 10198 and press Enter .
2)
At the OK prompt, type atds0<target node> (example: atds010198) and press
Enter .
Startup CTP
Screen
Figure 4-4 shows an example of the Vanguard 342 Startup Screen.
OK->atds->CONNECT
Figure 4-4. Vanguard 342 Startup CTP Screen
Connected to the Control Port
on Node
“
Nodename
”
, at 25-NOV-2002 13:32:59
Vanguard 340 - Model 342,
Version V6.2i_340