12
3. CONTROLS (
CONT
’
D
)
3.2
E
LECTRICAL
C
ONNECTION
TO
O
PTIONAL
W
ALL
C
ONTROLS
3.2.1 E
LECTRICAL
C
ONNECTION
TO
A
LTITUDE
OR
P
LATINUM
M
AIN
W
ALL
C
ONTROL
3.2.2 E
LECTRICAL
C
ONNECTION
TO
D
ECO
-T
OUCH
M
AIN
W
ALL
C
ONTROL
3.2.3 E
LECTRICAL
C
ONNECTION
TO
L
ITE
-T
OUCH
C
ONSTRUCTO
OR
B
RONZE
,
OR
S
IMPLE
-T
OUCH
C
ONSTRUCTO
OR
B
RONZE
M
AIN
W
ALL
C
ONTROLS
3.2.4 E
LECTRICAL
C
ONNECTION
TO
C
ONSTRUCTO
OR
B
RONZE
M
AIN
W
ALL
C
ONTROL
NO C NC I OC OL Y R G B
VE0181
SMART
SET
MODE
PREF
NO C NC I OC OL Y R G B
VE0250
NO C NC I OC OL Y R G B
B
G
OC
MAIN WALL CONTROLS
LITE-TOUCH CONSTRUCTO,
LITE-TOUCH BRONZE,
SIMPLE-TOUCH CONSTRUCTO
and SIMPLE-TOUCH BRONZE
REAR VIEW
G B
Y
VE0113A
NO C NC I OC OL Y R G B
VE0187
For more convenience, this unit can also be controlled using an optional main wall control.
NOTES: 1. The integrated control must be turned OFF to use an optional main control.
2. If an optional auxiliary control is used, if activated, this auxiliary control will override the optional main control operation.
CAUTION
Never install more than one main wall control per unit. Make sure that the wires do not short-circuit between
themselves or by touching any other components on the wall control. Avoid poor wiring connections. To reduce
electrical interference (noise) potential, do not run wall control wiring next to control contactors or near light dimming
circuits, electrical motors, dwelling/building power or lighting wiring, or power distribution panel.
Use the terminal connector included in the installation kit to perform the electrical
connection for main and optional wall controls. Check if all wires are correctly inserted
in their corresponding holes in the terminal block. (A wire is correctly inserted when its
orange receptacle is lower than another one without wire. On illustration at right, wire
A
is correctly inserted, but not wire
B
.)
Splice back the end of the cable to access the 4 wires. Strip the end of each wire.
Connect each wire to its corresponding terminal: YELLOW wire to “Y’’, RED wire to “R’’,
GREEN wire to “G’’ and BLACK wire to “B’’. Check if all wires are correctly inserted in
their corresponding holes in the terminal block.
Connect the auxiliary control cable, if installed (not shown).
VE0272
A
B
WARNING
Always disconnect the unit before making any connections. Failure in disconnecting power could result in electric
shock or damage of the wall control or electronic module inside the unit.
!
