background image

2

Congratulations

!

 

You have made an excellent choice! The operating principle of your Heat or Energy 

Recovery Ventilator will give you personal comfort you have never known before.

 

We have prepared this User Guide especially for you. Please read it carefully to 

ensure you obtain full benefit from your unit. Over the coming months, you will increasingly 
appreciate the feeling of living in a more comfortable house. 

 

Please take note that this guide uses the following symbols to emphasize particular 

information:

Identifies an instruction which, if not followed, might cause serious personal 
injuries including possibility of death.

Denotes an instruction which, if not followed, may severely damage the unit 
and/or its components.

WARNING

!

Make sure at all times that the outdoors intake and exhaust hoods are free from 
any snow during the winter season. It is important to check your unit during a 
big snow storm, so it doesn’t draw in any snow. If this is the case, please operate 
the unit in the recirculation mode, or turn it OFF for a few hours.

Do not use your unit during construction or renovation of your house 
or when sanding drywall. This type of dust may damage your system. 
Since the electronic control system of the unit uses a microprocessor, 
it may not operate correctly because of external noise or very short 
power failure. If this happens, unplug the unit and wait approximately 
10 seconds. Then, plug the unit in again.

CAUTION

CAUTION

NOTE: Indicates supplementary information needed to fully complete an instruction.

We welcome any suggestions you may have concerning this guide and/or the unit, 
and we would appreciate hearing your comments on ways to better serve you. Please 
forward all correspondence to us at the address indicated on the product registration 
card included with this guide.

When leaving the house for a long period of time (more than two weeks), a 
responsible person should regularly check if the unit operates adequately.
If the ductwork runs through an unconditioned space (e.g.: attic), the unit must 
operate continuously except when performing maintenance and/or repair. Also, 
the ambient temperature of the house should never drop below 18°C (65°F).
At least once a year, the unit mechanical and electronic parts should be inspected 
by qualified service personnel.

CAUTION

Содержание 40E 44262







Отзывы: