2 Installation
The ACTpro-1500 Controllers are for indoor installation only and must be installed as permanently
connected equipment.
An external mains disconnect device must be fitted. Before installation, ensure that the mains supply to
the controller is disconnected.
Mains power should be connected to ACTpro Controllers by a licensed electrician in accordance with
local/national codes.
After installing an ACTpro controller, Vanderbilt recommend that you place the provided ferrite bead (a
noise suppression device) around the Ethernet cable near the RJ45 connector to attain a desired level of
electromagnetic compatibility (EMC).
2.1 ACTpro-1500
2.1.1 Mounting
Mount the ACTpro Controller directly on to the wall with the supplied screws.
The keyed mounting hole should be screwed first to the wall to aid the mounting.
The unit should be installed in a ventilated area that allows for accessibility after installation.
2.1.2 Power supply
The ACTpro-1500 requires an external 12V DC or 24V DC power supply. The supply should be connected
to the +12/24V DC and 0V/GND connections.
2.2 ACTpro-15002A
This unit is only suitable for installation as permanently connected equipment.
l
The PSU is not suitable for external installation.
l
Equipment must be earthed.
Before installation, ensure that external disconnect device is OFF. The PSU should be installed via a 3A
fused spur according to all relevant safety regulations applicable to the application.
© Vanderbilt 2019
7
A-100535-c
15.03.2019
