Vanco D2.1, Руководство пользователя

Страница: 11 / 20

11
Connections
NOTE: Do not connect the AC power cord or turn the amp on until all connections have
been made and confirmed. Making connections with the power on can result in...well...
undesirable circumstances that may not be covered under the factory warranty.
OPTICAL IN (TV AUDIO CONNECTION)
1. Using a Digital Optical Audio cable, (Toslink) connect the Digital Optical Audio OUT on the
TV (or other source) to the Optical IN on the D2.1. To select this input, press IN 2 on the
D2.1 IR Remote.
SUB OUT (Beale Street Audio SUBWOOFER AMP CONNECTION)
1. Using a mono RCA-RCA cable with gold ends, connect the Sub OUT on the D2.1 to the Sub
IN on the Beale subwoofer amp , a powered sub or other subwoofer amplifier.
L- L+ R- R+ (SPEAKER CONNECTIONS)
1. Use16AWG (min) 2-conductor stranded speaker wire for speaker connection.
2. Strip approximately 1/2 to 3/4 of an inch off the ends and twist the strands together so
there are no loose ends that can cause shorts.
3. While observing proper wire polarity, insert the stripped and twisted ends of the speaker
wire into the appro and - terminals for the left and right speakers.
4. Tighten the terminal screws.
5. Confirm connection and polarity.
6. Connect the speaker wires to the appro and - terminals on the left and right
speakers.
7. Confirm connection and polarity.
LINE IN (AUXILIARY AUDIO SOURCE)
1. Using a stereo RCA-RCA patch cable connect the L&R line level audio OUTs on a Bluetooth
audio receiver or other source to the L&R Line IN on the D2.1. To select this input, press IN
1 on the D2.1 IR Remote.
RECEIVER IN (BLUETOOTH AUDIO STREAMING & AMPLIFIER SETUP)
1. Using a Cat5 patch cable with RJ45 connectors, connect the output of the Beale Street
Audio DBT-Taylor Programming Module to the Receiver IN port on the D2.1. For streaming
audio, see section Operation for information on pairing a Bluetooth device. For information
regarding the Taylor App, please visit www.getbeale.com for additional information.
AC POWER TERMINAL (100-240V-50/60Hz 2.5A)
1. After all connections have been made connect the supplied AC Power Cord to an
unswitched AC power outlet. Automatically selects AC power mode (110VAC/220VAC)
when connected to AC power.