Vancare VERA-LIFT II B350, Руководство по обслуживанию

Страница: 19 / 65

Technical instructions Control unit Mobilette
531e2931_0101 Magnetic – The Linear Drives Company™ page 9/11
Battery display / deep-discharge protection
To check the function of the battery display, place a discharged battery pack in the
Mobilette control unit and press one of the buttons on the control device.
If the battery is empty, the yellow LED will flash when a button is pressed.
Now press a button on the control device until an audible signal indicates the bat-
tery's deep-discharge protection. After this signal, it must once again be possible to
retract the actuator.
If the battery is completely empty when it is placed into the control unit, the audible
deep-discharge protection signal will sound.
"EMERGENCY STOP"
Test the EMERGENCY STOP function by pressing the "EMERGENCY STOP" button while
an actuator is being operated. The actuator must stop immediately. (See also 4.2)
5.3 Care
Protection from water, cleaning, disinfecting
The MCU1 has been manufactured according to protection class IPx4. Protection class
IPx3 applies to the MCU8 (MCU4).
Do not clean the control unit without properly connected actuators, control device,
sealed mains adapter and sealed actuator input (Fig. 11, Pos. and ‚) . The control unit
would be damaged by fluid entering it.
Maximum cleaning / drying temperature = 65°C!
If the unit becomes dirty, the housing should best be cleaned immediately in order to
prevent the accretion of residues!
Use a damp cloth and water for manual cleaning. Add a little isopropyl alcohol if nec-
essary.
5.4 Warranty
Assuming that the operating conditions are complied with and units have no mechan-
ical damage, a warranty of 12 months from the date of delivery will apply for all
mechanical and electrical components.
Batteries are not covered by this warranty.
5.5 Disposal
The control unit components and actuators may be returned to Magnetic AG, Liestal,
for disposal.
Damaged or worn batteries and chargers should only be replaced by the Magnetic
Service Department or trained personnel.
Special precautions are to be observed for
the ML 0111/87. Washing water with chem-
ical additives must be pH neutral. Exces-
sively acidic or alkaline washing water can
permanently damage the metal and plastic
components of the control unit.
Hand-held and mechanical high-pressure
steam cleaners must not be used. For man-
ual disinfection, only isopropyl alcohol
should be used.
1
2
Fig. 11 – Correctly closed control unit
Do not dispose of your batteries in domestic
waste.
Batteries must be recycled, disposed of prop-
erly or returned to Magnetic AG, Liestal.
February 2008 For your nearest Distributor, call 1-800-694-4525 19