Vancare VERA-LIFT II B350, Руководство по обслуживанию

Страница: 17 / 65

Technical instructions Control unit Mobilette
531e2931_0101 Magnetic – The Linear Drives Company™ page 7/11
4 Instructions for use
4.1 Controlling an actuator
The actuator is controlled directly using buttons
×
and
Ø
on the control device:
ƒ
Button
×
The actuator extends.
ƒ
Button
Ø
The actuator retracts.
When the button is pressed, the LED on the control device lights up green.
The battery status can be checked as follows during any motor movement via an LED
on the control unit (Fig. 8,
c
):
LED unlit Batteries are ready for operation.
LED flashes yellow Batteries must be charged, since they are
currently only charged to around 20%
A beep is heard The battery capacity is less than 20%, but there is still suf
ficient capacity for at least a double stroke. The batteries
must be charged immediately, otherwise the actuator's
deep-discharge protection will block further use! (See also
5.7 Troubleshooting)
4.2 EMERGENCY STOP function
Pressing the EMERGENCY STOP button interrupts the power supply to the actuators
and causes the actuator to stop immediately. The EMERGENCY OFF switch should only
be used in cases of immediate danger.
Pressing the EMERGENCY STOP
ƒ
Press the red button (A)
The button engages. The actuator stops and can no longer be controlled by the control
device while the "EMERGENCY STOP" button is locked in position.
Unlocking the EMERGENCY STOP
ƒ
Turn the red button in the direction of the arrow. (B)
The "EMERGENCY STOP" button is unlocked. The actuator can be controlled as before.
B
A
Fig. 9 – EMERGENCY OFF
Only use the Mobilette with charged batter-
ies. Operation with empty batteries is not
possible (not even if you connect the
MOBILETTE to the mains).
February 2008 For your nearest Distributor, call 1-800-694-4525 17