Van Gerven Anti Algae, Руководство пользователя

Страница: 6 / 32

6
Installation of the device (Drawing 1)
Never submerge this device in water. Always install the device outside of the pond. Ensure that water is always flowing through the unit when
the electrolyzer is switched on.
1 Determine where the unit will be installed.
2 Fit the display box ( B ) at the selected location. The plug is situated on the top of the unit.
3 Install the unit into the circuit using the 3-part couplings ( F ).
4 Make sure there is sufficient space available (+/- 30 cm) to remove the copper unit (
A
) in order to replace it and/or for maintenance.
5 Switch the pump on and check the system for flow and leakage. Pay hereby attention to the correct position of the sealing rings ( D ).
6 Put the plug of the unit in a wall socket with a safety ground and fitted with a residual current circuit-breaker.
7 The unit is switched off completely by pulling the plug out of the socket.
Dismantling / Maintenance / Copper replacement
Always switch off the power supply during maintenance/dismantling of the device.
1 Unscrew the three-part couplings ( F ) and drain the water from the unit.
2 Using a screwdriver, click the black fastening clip (H) from the screw ring (E) (see drawing 2).
3 To replace the copper unit (
A
) (
see drawings 4, 5
), unscrew the protective cover (
R
) from the connector strip (
S
) using a screwdriver, and
disconnect the wiring from the connector strip.
4 Then unscrew the screw ring ( E ) on the bottom of the device. Carefully remove the copper unit using a large, flat screwdriver ( see drawing
3 ). Never use force! Then place a new copper unit in the device and connect the wiring again via the connector strip ( see drawings 4, 5 ).
Ensure that the colours of the cables correspond with each other: Blue with blue, brown with brown. To finalise, tighten the screws of the
connector strip. Replace the protective cover over the connector strip. Check that the black outer casings of both pieces of cable are inserted
far enough into the connector, and screw the lid down.
5 The electrical unit of the device is located in the display box (
B
). This display box is glued and cannot be opened. In case of any doubt with
regard to the connection, consult a recognised fitter.
Technical specifications
• Pond content (l) max 120,000 l
• Maximum throughput 10,000 l/h
• Maximum copper content 0.8 ppm.
• Maximum pressure 1 bar
• Maximum temperature 50 °C
• Minimum temperature 0 °C
• Connection diameter Ø 48 / Ø 50 mm
• Length of the device 35 cm
Terms of guarantee
You have made an excellent choice in selecting this product. The device has been assembled carefully and in compliance with all applicable
safety regulations. For reasons of quality, the supplier has only made use of high-quality materials, and provides a guarantee for the device
covering material and manufacturing faults for a period of 2 years from the date of purchase. Claims under the guarantee can only be considered
if the product is returned post-paid together with a valid purchase receipt. The guarantee cannot be invoked in the case of errors in the
installation or the operation, incorrect use of the device, non-compliance with the safety regulations, poor maintenance, damage to the device,
or if any technical changes have been made to the device. In the case of warranty claims, the supplier reserves the right to repair or replace the
unit as a whole as he deems appropriate. Consequential damage is excluded from the guarantee. Complaints regarding transportation damage
will only be considered if the damage was established or confirmed upon delivery by the carrier or the postal authorities. A claim can only be
made against the carrier or postal authorities if this has been done.
Manual anti algae electrolyzer.indd 6 20-04-11 10:31