ENGLISH
MD 950
/ NanoPak
Introduction
Chapter 1
Page GB 6
9.694.038
V 4.02
1.4 Safety instructions
Our products are in a flawless condition in terms of safety technology when
they leave the plant.
To maintain this condition, the contents of these safety instructions as well
as type plates, labelling and safety instructions attached to the device must
be observed while handling the device (transport, storage, installation,
commissioning, operation and maintenance).
This device is suitable for processing laminated films in the heat-sealing
process. See also chapter 1.6 "Intended use".
Please check the packaging, and lodge a complaint for any damage with the
carrier or parcel service immediately, before installing the device.
Before commissioning, ensure that the device does not show any evidence
of damage. In case of doubt, contact the manufacturer or a service partner
authorised by the manufacturer.
Do not operate the device if the power cable or the power plug is damaged.
Do not use the device if it does not operate correctly or it is damaged in any
way. If the mains cable or the device have been damaged, the device must
be repaired by the manufacturer or by one of the manufacturer's authorised
service partners.
The device must be connected using the mains cable included in the scope
of delivery to a protective contact socket with a stable voltage. Operation on
IT networks is not permitted.
Place the device on a stable base.
The device must not be installed or operated
in potentially explosive areas.
If the sealing device is brought directly from a cold environment into a warm
environment, condensation may form. Wait until temperature equalisation
has taken place.
Repairs and the replacement of spare parts must be performed only by the
manufacturer or by one of the manufacturer's authorised service partners.
Switch off the device when it is not in use, or remove the power plug from
the socket.
Do not insert pointed or flat items into the import slot of the device. This can
result in damage to the device and instruments.
Do not insert items into the louvres of the device. You might receive an
electric shock or the device could be damaged.
Do not use the device if you have any doubts about its safety.
