Van der Ende Groep · Aartsdijkweg 23, 2676 LE, Maasdijk · Tel. 0174 515050
IBAN NL71 RABO 0340341610 · KvK Den Haag 27230471 · Btw-nummer NL8000.78.378.B01 · [email protected] · www.vanderendegroep.nl
Page 13 of 32
-
fit two cover plates, lying onto each other (14), in the profile;
-
Mount the second end plate with six 4,8x16 metal screws (6). Don
’
t screw the metal screws
fully fixed so there is some mo
vement into the Airmix™ hou
sing left.
-
Place two 4,8x13 metal screws with tapping point (8) with corresponding fender washers m5
(7) into the second end plate. Don
’t screw the metal screws
fully fixed too so there is space
left to fine tune the end plate against the lattice (1).
-
slide the Airmix
™
housing (23) between the profiles up to the end plate; attach it with six
M8x16 hexagonal bolts (9) and six M8 fender washers (13);
-
put the cover plates in position and attach to each other with a 4.8x13 metal screw with
tapping point (8);
-
lift the whole unit to the lattice and slide four Slide-in brackets (11) through the top of both
end plates so these Slide-in brackets rest on the lattice.
o
Make sure the correct right slot is used for the Slide-in brackets. This is important for
the height related to the screen. See Figure 7.
-
Make sure the end plate (5) is fully against the lattice. If so, connect the Slide-in brackets to
the end plate using one m8x16 stainless steel bolt (9), two washers m8 (10) and one self-
locking nut m8 (12).
-
Connect the Slide-in brackets (11) to the lattice (1) with two metal screws with tapping point
4,8x13 (8).
-
put the profile connector (17) in place, by turning it in the groove of the profiles, under the
overlap of the cover plates.
Figure 7: mounting the Slide-in brackets into the end plate
