Van der Ende Groep · Aartsdijkweg 23, 2676 LE, Maasdijk · Tel. 0174 515050
IBAN NL71 RABO 0340341610 · KvK Den Haag 27230471 · Btw-nummer NL8000.78.378.B01 · [email protected] · www.vanderendegroep.nl
Page 12 of 32
-
fit a mounting strip (3) with an M6x12 set screw (4) in the groove of the profile (2), the first
M8 tapped hole 210mm from the end of the profile; tighten the set screw; do this for two
profiles. See Figure 5:
Figure 5 Mounting strip
-
Insert a
¼’’
plug (20) in the end plates;
-
Attach two attachment profiles (2) into one end plate (5) with six metal screws 4,8x16 (6).
Make sure the holes of the end plate and attachment profiles line up nicely and look if there is
no space left between the attachment profiles and the endplate.
o
Use
max. 150 Nm
to put the metal screws 4,8x16 (6) into the attachment profiles.
Otherwise the screw could break or the aluminum wears out.
-
put two 4,8x13 metal screws with tapping point (8) with corresponding fender washers m5 (7)
through the slotted holes in the side of the end plate (5) and into the aluminum attachment
profiles. Put the metal screws into the middle of the slotted hole.
Figure 6: mounting the metal screws into the end plate
