VAN DER ENDE 21/35 E, Руководство по установке

Страница: 6 / 30

Montagehandleiding Enpres
Van der Ende Groep · Aartsdijkweg 23, 2676 LE Maasdijk, the Netherlands
+31 174 515 050 · info@vanderendegroep.nl · www.vanderendegroep.com
Page 6 of 30
IMPROVING YOUR BUSINESS
Picture 2. Schematic representation of the pressure regulator.
Letter Function
A Turning knob for the regulation of the outgoing pressure.
B Overflow connection.
C Handle for the opening or closing of the pressure line to the installation.
D Handle for the pressure free starting of the pump, in the shown position the pump will
start pressure free.
E This pressure gauge displays the outgoing pressure.
Table 4. Controls pressure regulator
When starting the pump, handle D must be vertical, so that the pump can start pressure free and a
high initial current is prevented. Put the three position to the star position to start the motor. Switch
to the delta position after the electromotor has been running for a few seconds. If everything works
correct, there must be fluid coming out of the overflow connection and the pressure gauge displays
(as good as) zero pressure. When handle D is now set in the horizontal position the pump will start
delivering pressure, this pressure can be regulated with the turning knob A. (For an extensive
description of the starting procedure see chapter 5.)
Handle C enables the user to close or (partially open) the pressure line to the installation.
1.4 Intended users
Intended users/installers are any person of 18 years and older working at the company the Enpres is
(going to be) installed, who have the competence and authority to work with or install the Enpres.
Unintended users/installers are any person who don’t apply to the above description. Also, unintended
users/installers are users/installers who cause unsafe situations and/or dangers for themselves or
others by using/installing the Enpres.
1.5 Use of the Enpres
The Enpres is intended for use as a high pressure piston pump in a suitable installation/system in
combination with fluid media.
The Enpres is not intended for use other than described above.