Valtra 600, Руководство оператора

Страница: 43 / 142

---42--- D. Instruments and controls
D 2.4.1.10.
Passing switch for position control
knob = forced lowering switch (1
.10
)
1
.10
1
.11
69--- 31,2
By pushing this switch, the lower links are lowered below
the position, set by the position control knob (
1.2 ). After
releasing the switch the lower links return to the value, set
by the position control knob. The switch is spring loaded.
The forced lowering only operates when the lift/stop/lower
switch (
1.3 ) is in the lowering = Autocontrol position. The
forced lowering switch uses the lowering speed set by the
lowering speed selector.
D 2.4.1.11.
Inner switch for connecting imple-
ment (1
.11
)
The lower links are raised and lowered by the switch in
the cab and by push button on the rear mudguards.
These are useful, for instance, when implements are being
attached. The lower links lift or lower as long as the
corresponding switch/button is pressed. The switch/push
buttons operate when the lift/stop/lower switch (
1.3 ) is in
the lower position or the centre position.
After these switch/buttons have been used the position
control system must be activated by operation of the
lift/stop/lower switch (
1.3 ).
CAUTION: The transport height selector (1.6) does not
limit the lifting height when these switch/buttons are
being used.
The lower link position sensor does not limit the lifting
height when the switch/push buttons are used; instead the
arms are moved to their extreme positions when the
switch/buttons are pushed.
D 2.4.2.
Side pillar control panel (2)
D 2.4.2.1.
Rear window wiper and washer (2
.1
)
(extra equipment)
2
.4
2
.3
2
.2
2
.1
69--- 31,3
The switch controls both the windscreen washer and
wiper.
D 2.4.2.2.
Change over switch for LCD---display in
Agroline---instrument panel (2
.2
)
The tractor is fitted with this switch, if equipped with Agro-
line---instrument panel.
The operation of change over switch for LCD---display unit
is explained under “Agroline---instrument panel” starting
on page 34.
D 2.4.2.3.
Switch for front working lights (2
.3
)
(extra equipment)
The parking lights or full/dipped---beam headlights must
be switched on when using the working lights.
D 2.4.2.4.
Switch for upper headlights (2
.4
)
(extra
equipment)
When this switch is pressed the upper headlights are
switched on. When the upper headlights are on the lower
headlights in the front are off and vice versa.