Page 5
SKU 92493
For technical questions, please call 1-800-444-3353.
Noise Precautions
The generator can produce high noise levels. Prolonged exposure to noise levels above 85
dBA is hazardous to hearing. Always wear ear protection when operating or working
around the generator when it is running.
Electrical Precautions
1.
All connections and conduit from the generator to the load must only be installed by
trained and licensed electricians, and in compliance with all relevant local, state, and
federal electrical codes and standards, and other regulations where applicable.
2.
The generator / welder must be earth-grounded in accordance with all relevant
electrical codes and standards before operation.
3.
Before performing any maintenance or connecting or disconnecting any electrical load
connections, the engine must be disabled.
4.
Do not attempt to connect or disconnect load connections while standing in water, or
on wet or soggy ground.
5.
Do not touch electrically energized parts of the generator / welder and interconnecting
cables or conductors with any part of the body, or with any non-insulated conductive
object.
6.
Connect the generator only to a load or electrical system that is compatible with the
electrical characteristics and rated capacity of the generator.
7.
Before servicing equipment powered by the generator, disconnect the equipment from
its power input.
8.
Keep all electrical equipment clean and dry. Replace any wiring where the insulation
is cracked, cut, abraded or otherwise degraded. Replace terminals that are worn,
discolored, or corroded. Keep terminals clean and tight.
9.
Insulate all connections and disconnected wires.
10.
Use only Class BC or Class ABC fire extinguishers on electrical fires.
General Precautions
1.
Check for damaged parts. Before using the generator/welder, any part that appears
damaged should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment and binding of moving parts; any
broken parts; and any other condition that may affect proper operation. Any part that
is damaged should be properly repaired or replaced by a qualified technician.
2.
People with pacemakers should consult their physician(s) before using this product.
Electromagnetic fields in close proximity to a heart pacemaker could cause
interference to, or failure of the pacemaker. In addition, people with pacemakers
should adhere to the following:
Caution is necessary when near the coil, spark plug cables, or distributor of a running
engine. The engine should always be off if adjustments are to be made.
