Page 13
SKU 92493
For technical questions, please call 1-800-444-3353.
ASSEMBLY INSTRUCTIONS
Before operating the generator/welder, the following items have to be installed: Handle
Bars, Wheel kit, and Front Support Bracket.
Handle Bar Installation
1.
Unpack and review all parts for defects or missing items.
2.
Find two Brackets (21) and four Bolts, Washers, and Nuts. See photo below showing
completed assembly of Handle Bars.
3.
Attach each Bracket to the Frame using two Bolts, Washers, and Nuts. Securely
tighten. (Handle Bar holes in Brackets must face inward.)
4.
Find two Handle Bars (17) and push on the rubber Grips (6) onto the Handle Bar
ends (opposite the end with the key tabs).
5.
Insert the Handle Bars (17) through the holes in the Brackets (21). Note that the
Handle Bars have a key tab on the end and can only fit through the holes one way.
6.
Once inserted, turn the Handle Bars one half turn so they cannot slide out.
Wheel Installation
1.
Find two Wheels (19), two Axles (18), and two Cotter Keys.
2.
Loosen the Set Screws on each Axle Sleeve using a Hex Wrench (not supplied), and
slide in the thick part of the Axle (18). Securely tighten each Set Screw. See photo on
the next page.
3.
With the help of another strong person, lift the unit by its Handle Bars (17) and front roll
cage, high enough to insert two, six inch blocks under each side of the Frame.
Brackets (21)
Handle Bars (17)
Grips (6)
