START USING THE VALORE ARMOA DIFFUSER
1. Open the cover and add moderate water. The water line shall reach over the water sensor
and below the max water level line. After that, you may put in a few drops of essential oil.
2. Connect the USB cord with any USB power source.
3. Once the power is connected, the diffuser will have a flash yellow light to indicate that the
power is connected, and the diffuser will be on standby.
4. Press the spray button once to switch on the continuous spraying mode, or twice to switch to
the intermittent spray mode. Press one more time to switch the diffuer to standby mode.
5. Press the light button once to switch to warm light, or twice to switch on the seven colours.
Press one more time to turn the lights off.
Note:
• Please do not remove the splash board while adding the water into the diffuser, in case the
amount of water exceeds the maximum water level.
• When the water runs out (While the water is lower than the water sensor), the spray function
will stopped automatically. There will be a red light flashing five times to indicate the water
shortage, and the diffuser will be switched to standby mode.
Add in water and essential oil
Connect to power supply
Setup spray function and light
Pull up the cover