6
Figure
4.
Fire Surround:
This appliance may be installed
with a surround with a minimum approved
temperature rating of 150 degrees. The fire
surround must be sealed to the wall.
Hearth Requirements:
The appliance must be
mounted on a non-combustible hearth in
accordance with Figure 3. The hearth material must
have a minimum thickness of 12.5mm (1/2”). The
periphery of the hearth (or fender) should be at least
50mm above floor level to discourage the placing of
carpets or rugs over it.
INSTALLATION AND COMMISSIONING INSTRUCTIONS
PLEASE READ CAREFULLY BEFORE STARTING WORK
Fireplace, Flue and Ventilation Details
Read the important installation notes on the previous pages before proceeding with the installation of your fire.
Only when you have complied with all the requirements should you proceed any further.
Note the hearth
requirements
.
Remove any transit tape and packing and inspect for any evidence of mishandling which might affect the
performance. Each unit is flame and soundness tested before it leaves the factory and as a result there may be
slight discoloration around the burner ports.
8mm (5/16) Bundy or semi-rigid tubing must be used to connect the appliance to the gas supply.
If a concealed gas pipe fixing is to be used, offer the gas pipe through the appropriate grommet. A nut and olive
are provided for an 8mm pipe inlet connection to the elbow at the bottom front of the appliance. The elbow
can be rotated to allow a connection from any direction. The elbow includes a valve for isolating the gas supply.
The burner assembly is retained by two
screws positioned at each side of the
burner tray assembly and one positioned
through the front leg. (see Fig.4).
Carefully remove the burner assembly
by lifting and sliding forward from the
firebox.
Fit Foam Seals:
A foam seal is
supplied which will need to be attached
to the rear face of the firebox frame on
all three sides. Ensure that all joints are
butted together to prevent air gaps.
Figure 3 Hearth
