13
FITTING THE CAST FASCIA.
Ensure the fire has been turned off and has been allowed to
cool before fitting the fascia.
The Bolero is supplied with a high grade cast fascia and fire
front. Remove the fascia from the packaging taking care
not to use a sharp implement that may scratch the surface
of the fascia. Remove the transit packing and offer the
fascia to the appliance frame, lift the fascia and locate the
fastening tabs to the retaining brackets on the appliance
frame. See fig 15.
Position the firefront centrally in front of the fascia.
FINAL REVIEW
Hand these instructions and the user’s instructions to the customer.
Advise the customer how to operate the appliance.
Explain to the customer that the appliance has a flame failure and spillage monitoring system. Point out the
explanation of this system shown in the users instructions under “Operating the Fire”. Advise that if the fire
goes out for any reason, wait at least three minutes before relighting.
Stress that if the monitoring system repeatedly shuts off the fire, the appliance should be switched off and a
specialist should be consulted.
Advise the customer that the castings, front surround, firebox and ceramic pieces can be cleaned as described in
the user’s instructions and that the coal pieces must be replace as described in those instructions.
Stress that no extra coals must be added over and above those supplied with the appliance and that any replacements
must only be the authorised spares. Warn that ignoring this advice could cause incomplete clearance of the products
of combustion with consequent health hazards.
Recommend that the appliance should be serviced and the chimney inspected by a competent person (In the
UK a CORGI registered person) at least annually.
If the appliance is in premises in the United Kingdom occupied by a tenant, point out that by law a landlord
must have any gas appliance, flue and pipework which is situated in a tenant’s premises checked for safety at
least every 12 months.
Figure 15 Fitting The Cast Fascia
