4
A fireguard complying with BS6539 or BS6778 should be fitted for the protection of young children, the elderly, or
the infirm.
In the United Kingdom (GB) no special ventilation bricks or vents are required in the room for this appliance.
However, any requirement relating to other appliances which may be in the same room must be taken into
consideration.
In the Republic of Ireland (IE), permanent ventilation must comply with the regulations currently in force.
An extractor fan may only be used in the same room as this appliance, or in any area from which ventilation for the
appliance is taken, if it does not affect the safe performance of the appliance. Note the spillage test requirements
detailed further on in this manual. If the fan is likely to affect the appliance, the appliance must not be installed
unless the fan is permanently disconnected.
The appliance is fitted with an A.S.D (Atmosphere sensing device). If the appliance closes down after a period of
operation for no apparent reason, the consumer should be informed to stop using the appliance until the
installation and appliance have been thoroughly checked. The A.S.D will shut the appliance down if an
unacceptable amount of harmful products of combustion accumulate. Under no circumstances should the A.S.D
be altered or bypassed in any way. Only a genuine Valor supplied replacement part should be fitted. The individual
A.S.D components are not replaceable.
Note that soft wall coverings (e.g. embossed vinyl, etc.) are easily affected by heat. They may scorch or become
discoloured when close to a heating appliance. Please bear this in mind when installing.
TECHNICAL SPECIFICATION
Fire surround height:
620mm
Fire surround width
560mm
Appliance insert depth:
233mm
Height of opening required:
535mm min.
570mm max.
Width of opening required:
405mm min.
490mm max.
Gas:
Natural Gas (G20)
LPG Propane (G31)
Conversion kit 591159.
Inlet Pressure:
20mbar (8in. w.g)
37mbar (14.8in. w.g)
Max. input (Gross):
6.85kW (23,375 Btu/h)
6.7kW (22,860 Btu/h)
Min. input (Gross):
2.2kW (7,500Btu/h)
3.6kW (12,280Btu/h)
Burner Test Pressure (cold):
17.3+0.75mbar (6.9+0.3in. w.g.)
35.1+0.75mbar
(14.1+0.3in. w.g.)
Gas connection:
8mm pipe.
Burner Injector:
Bray Cat 31 Size 440
Bray Cat 18 Size 180
ASD Pilot::
SIT ref. OP NG 9030
SIT ref. OP LPG 9222
Ignition:
Piezo electric. Integral with gas tap
Aeration:
Non adjustable.
Clearance to combustible side panels: 100mm
The minimum height from the top surface of the hearth to the underside of any shelf made from wood or other
combustible materials is as follows:-
•
For a shelf up to 150mm deep
Minimum height = 750mm.
•
For a shelf deeper than 150mm
Minimum height = 750mm + 12.5mm for every 25mm depth over 150mm.
PACK CONTENTS
1 Burner & Fire Box Unit
2 Cable Retention Bolts
1 Nut & Olive for 8mm inlet pipe
2 Fire Retaining Cables
1 Front Coal
1 Owners Guide
1 Main Coal Bed
1 Burner Tray Trim
1 Pack 14 Loose Coals
1 Rear Support Bracket
3 Self Adhesive Foam Seals
1 Floor Sealing Tape
2 Fibre Wall Plugs
1 Front Casting Pack
2 Eyebolts
1 Guarantee Pack
