14. FITTING THE FASCIA
14.1 Fitting the Blenheim fascia.
Fitting the fascia.
1.
The fascia is supplied in three pieces.
Carefully remove the three fascia pieces from
the packaging. Remove any protective film.
2.
The magnets used to locate each fascia trim
should already be positioned on the rear of
each trim. Each fascia trim should have two
magnets. If the magnets are not fitted then
locate one magnet centrally at each end of the
trims.
3.
Locate the side fascia trims as in figure 26.
4.
Locate the top fascia trim as in figure 26.
Fitting the firefront and ash pan.
1.
Place the firefront centrally on the hearth in
front of the fascia.
2.
Place the ash pan in position
below the firefront.
14.2 Fitting the Dream fascia.
Fitting the hood / canopy to the
fascia.
Locate the hood to the fascia as in
figure 27. Secure in place using four
No.8 x 10 screws.
©
Baxi Heating U.K. Limited 2011.
Page 32
Figure 27. Hood / Canopy location
Figure 26. Fascia location
INSTALLER GUIDE
