5.
There is a length of self adhesive foam
seal supplied with the fire. This will need to
be fitted to the outer rear edges of the side
and top flanges of the hotbox. Cut a
485mm length of foam seal. Be careful not
to stretch the seal when measuring.
Remove the protective backing from the
foam seal and fit this to the rear of the top
flange (See figure 13). Cut two 580mm
lengths. Fit these to the rear outer edges
of the side flanges. Ensure that there is no
gap between the foam seals where they
meet at the top flange (See figure 13)
6.
This appliance is supplied with a rear
ceramic support bracket. Fit this using two
‘B’ screws supplied (See figure 14).
Page 25
©
Baxi Heating U.K. Limited 2011.
INSTALLER GUIDE
Figure 14. Fitting the rear ceramic
support.
Figure 13. Fitting the foam seal
