Fitting the fascia.
1.
Carefully lift the fascia. Place the
fascia against the fireplace front
surface so that the two retaining plates
at the back of the fascia are directly
above the two upper retaining brackets
at the top of the hotbox. Lower the
fascia unit making sure that the
retaining plates locate fully into the
brackets on the hotbox (See figure 28).
If the inlet pipe runs along the front of
the fireplace, the bottom of the fascia
will have to be swung forward to clear
the pipe while lowering the fascia.
2.
Secure the bottom of the fascia using the two machine screws and washers
supplied (See figure 29 - Refer to the ‘Contents’ section of this guide for details).
Fitting the firefront and ash pan.
1.
Place the firefront centrally on the hearth in front of the fascia.
2.
Place the ash pan in position below the firefront.
14.3 Fitting the Petrus fascia.
Fitting the fascia.
1.
Carefully lift the fascia. Place the fascia against the
fireplace front surface so that the two retaining plates at
the back of the fascia are above the two upper retaining
brackets at the top of the hotbox. Lower the fascia
making sure that the rear retaining plates locate fully
into the retaining brackets on the hotbox (See figure
28). If the inlet pipe runs along the front of the fireplace,
the bottom of the fascia will have to be swung forwards
to clear the pipe while lowering the fascia.
2.
Secure the bottom of the fascia using the two
machine screws and washers supplied (See figure 29 -
Refer to the ‘Contents’ section of this guide for details).
Page 33
©
Baxi Heating U.K. Limited 2011.
Figure 29. Fascia securing
(Fascia may differ from that
shown).
Figure 28. Fascia location (Fascia may differ
from that shown).
INSTALLER GUIDE
