Valor 855 Dimension, Инструкция для установщика и владельца

Страница: 13 / 24

6.
Position the heater in front of the fireplace
opening.
7.
At the top of the heater there are four
small holes, two each side of the heater.
From the front of the heater, thread about
50mm of the wire into the outside small hole
on the right side of the heater (See point 1 -
figure 10).
8.
Thread the other end of the wire through
the remaining small hole to the left. Continue
to push the wire through this hole until there
is only a small loop of wire at the front of the
heater (See point 2 - figure 10).
9.
At the back of the heater there will be a
long piece and a short piece of wire coming
through the two holes. Hold the short piece
and give the long piece a gentle tug. This will
secure the wire. Take the long piece and thread this through the screw eye in the
back of the fireplace opening (See figure 10).
10.
From the back of the heater thread the long piece of wire through the inner small
hole on the left hand side of the heater (See figure 10).
11.
Locate the heater in the fireplace opening, then from the front of the heater, gently
pull the wire on the right hand side to gather up the excess until the heater is secure.
Thread the wire through the remaining small hole to lock the wire and heater in place
(See point 4 - figure 10).
Method C - Securing with the Optional Spacer Frame.
The spacer frame enables the heater to be flat wall fixed. For your safety the frame
and heater must be securely fixed to the rear wall / surround.
Fitting the spacer frame
The rear of the spacer has two screw
location slots in the top flange. These
should be to the rear when fitting.
1.
Position the spacer frame against the
wall. Ensure that the spacer frame is
central to the fireplace.
2.
The top rear flange of the spacer frame
has two screw locations. Mark the
positions of the two screw locations on the
rear wall (See figure 11).
3.
Remove the spacer frame from the
fireplace and place away from the work area.
4.
Drill the locations using a suitably sized masonry drill bit for the wall plugs supplied.
Page 13
©
GDC Group Ltd. 2011
INSTALLER AND OWNER GUIDE
Figure 10. Wire fix
Figure 11. Location points