INSTALLER’S GUIDE
Page 37
•
Place the new left hand plaque in position. The left side of the plaque must touch the
inside edge of the retaining flange at the left side of the burner well.
•
Place the new right hand plaque in position. Make sure that the centre section of the
combination gasket is between the two plaques. If there is any play between the plaques
and the end retaining flanges, push the plaques firmly to the left squeezing the centre
section of the combination gasket between the two plaques. Any gap should be between
the right side of the plaque and the right side-retaining flange.
•
Fit the front and rear plaque clamping strips. Make sure that the plaques are as far to the
left as possible. .
It is important that the left side plaque is accurately positioned so
that it has the correct relationship to the pilot.
Fully tighten the clamping strips.
•
Refit the coals/ Pebbles as described in section 8 of this guide. Refit the decorative
firefront.
12. SHORT LIST OF SPARES
DESCRIPTION
NO.
OFF
MAKER’S PART NO.
MODEL
639 (Nat. Gas)
639 (Propane)
Pilot unit
1
720A249
720A300
Burner injector
1
720A072
3002350
Burner plaque & gasket set
1
000A913
000A931
Gas tap
1
3002368
3002368
(Models with ‘Coal’ fuel
effect bed)
Coal matrix
1
3002190
3002190
Front coal Set
1
3002330
3002330
Pack of 12 loose coals
1
3002193
3002193
(Models with ‘Pebble’ fuel
effect bed)
Pebble matrix
1
3002448
3002448
Front Pebble set
1
3002516
3002516
Pack of 16 loose pebbles
1
3002442
3002442
Because our policy is one of constant development and improvement, details may vary
slightly from those given in this publication.
© Valor Heating
