9
WARNING
DO NOT ATTEMPT TO TOUCH THE INFORMA-
TION CARD WHILE THE FIREPLACE IS STILL
HOT!
Let the
fi
replace cool
fi
rst before touching it.
Wall Switch
(optional)
Remote control handset
AM
Thermostatic
Remote Control
Wall Switch
(optional)
!
ON: parallel to pipe
OFF:
perpendicular
to pipe
3. Slide the receiver battery compartment’s cover off.
4. Replace the batteries with 4 AA
alkaline
batteries
orienting them as indicated inside the compartment.
5. Replace the cover.
6. Put the receiver back in its location at the left of the
gas valve.
7. Reinstall the removable panel sliding it back under
the side doors until it is
fl
ush with the sides of the
trim.
8. Reinstall the barrier screen.
Using Handset Wall Holder
Your
fi
replace equipment includes
a wall holder to store the handset.
If it hasn’t be installed, refer to the
instructions further on in this manual
for the installation.
Locating Lighting, Operation and Rating
Information Card
The Lighting, Operation and Rating Information card is
located at the right hand side of the
fi
rebox behind the
side door panel.
To access the information card, unhook the barrier
screen and remove the right side door by pulling on it
sideways.
The card is permanently attached by a wire to the
fi
rebox. Pull it out and read the important information
on both sides.
Servicing Your Fireplace
If any attention is required for your appliance, contact
your supplier quoting the model number. It will be
helpful if the appliance’s serial number can also
be quoted. This number is on the rating plate. The
replacement parts are shown at the end of this manual.
Please always quote the part number and description
when requesting spare parts.
Operating Your Fireplace
There are two ways to control your
fi
replace.
1. Thermostatic Remote Control;
2. Wall Switch (optional).
The Thermostatic Remote Control can be programmed
to function automatically—see pages 11–15.
The Wall Switch can be used to turn on, off and to
increase or decrease the
fl
ame height—see the
1265WSK—Wall Switch Kit.
How to Turn Your Fireplace OFF
(including pilot)
Familiarize yourself with each of the following methods
before operating your
fi
replace.
Press and hold for 4 seconds the button on the
handset or OFF button on the optional wall switch.
NOTE:
The
fi
rst tap on the button “wakes up” the
handset. Tap again to use the function.
If the
fl
ames are on, they go down and you hear the
valve motor wind down. You hear a clunk and a beep
indicating that the valve has received the signal from
the remote control.
As well, familiarize yourself with the gas shut-off valve
location in your house. As indicated below, the gas is
running when the handle is parallel with the pipe. The
gas is off when the handle is perpendicular with the
pipe.
Owner’s Information
OWNER’S
INFORMATION